• linkedin (2)
  • sns02
  • sns03
  • sns04
page-banner

plasma power source

  • CNCAM HP Plasma Source Introduction

    CNCAM HP Plasma Source Introduction

    These operation instruction is prepared for experienced operator. you should be familiar with arc welding and cutting equipment’s operation.

    Please not let non-training workers installation. Operate. Maintenance this equipment.

    If you can not understand this instructions, please contact your supplier for more information.

    Before installation and operation this machine, please make sure read above safety and notes.

  • LGK-100/120/160/200/250 Thyristor Rectified Air Plasma Cutting Machine

    LGK-100/120/160/200/250 Thyristor Rectified Air Plasma Cutting Machine

    100% (40℃)duty cycle;

    Cutting current is continuously adjustable, suitable for welding both thin and thick plate;

    It will stop cutting automatically when lack the Air pressure or hydraulic pressure to protect the torch from burnt;

    There are arc sync signal and arc voltage signal connector which are easy for auto cutting and especially suitable for matching with numerical control machine and robot;

    Cutting current upslope can be adjusted to prevent damages of nozzle and electrode;

  • Powermax45 85 105 plasma cutter

    Powermax45 85 105 plasma cutter

    Powermax45 XP plasma cutter Capacity Thickness Cut speed Cutting Recommended 16 mm (5/8″) 22 mm (7/8″) 500 mm/min (20 ipm) 250 mm/min (10 ipm) Severance (hand cutting) 29 mm (1-1/8″) 125 mm/min (5 ipm) Pierce* 12 mm (1/2″) Powermax65 SYNC plasma cutter Capacity Thickness Cut speed Recommended 20 mm (3/4″) 500 mm/min (20 ipm) 25 mm (1″) 250 mm/min (10 ipm) Severance (hand cutting) 32 mm (1-1/4″) 125 mm/min (5 ipm) Pierce* 16 mm (5/8″) Powermax85 SYNC plasma cutt...